Chairs & seating

The hardest thing we make, and the most used.

Dining chairs, benches, counter and bar stools. A chair takes leverage no table ever sees, so every joint is cut for that load and every curve is checked against a body.

Set of white oak dining chairs with sculpted joinery in a sunlit studio

01 — Seating

Made to match the table, or to stand alone.

  • White oak dining chairs with sculpted joinery

    01

    Dining chairs

    Side chairs and armchairs in sets, shaped seats, backs angled for long dinners rather than quick meals.

    Illustrative image

  • Close-up of precise dovetail and mortise-and-tenon joinery

    02

    Benches

    Dining benches cut from the same boards as the table, entry benches, and long seats for restaurants and banquettes.

    Illustrative image

  • Kitchen island with a wood and smoky resin countertop

    03

    Counter & bar stools

    Sized to the exact counter or bar height, with footrests placed where feet actually land and finishes that shrug off boots.

    Illustrative image

02 — What makes a chair right

Comfort is measured in inches.

These are the starting dimensions. For a set, we recommend approving one finished chair before the rest are built.

Dining seat height
About 18 in (46 cm) for a 29 to 30 in table.
Counter stools
Seat about 24 to 26 in (61 to 66 cm) for a 36 in (91 cm) counter.
Bar stools
Seat about 28 to 30 in (71 to 76 cm) for a 42 in (107 cm) bar.
Seat depth
Deep enough to sit back, short enough that the front edge never presses behind the knee.
Arms
Armrests checked against the table apron so the chair still slides all the way in.

03 — Joinery

Every joint sized for leverage.

People lean back. A rear leg joint carries forces many times a sitter’s weight, so chairs get the deepest joints in the shop.

  1. 01

    Deep mortise and tenon

    Long tenons with tight shoulders at the seat rails, where a chair takes its hardest leverage.

  2. 02

    Grain that runs with the load

    Curved parts are laid out so the grain runs through the curve, not across it, to avoid short grain that snaps.

  3. 03

    Species chosen for strength

    White oak, ash, maple and walnut all make honest chairs; soft slab woods stay on tabletops.

Seating for a table you already own?

Send its height, its apron depth and a photo. We start from there.

Start a commission